Low Energy Lighting Building Regulations
Californias 2008 Long-Term Energy Efficiency Strategic Plan also set the goal that all new low-rise residential construction in the state be zero net energy ZNE by 2020.
Low energy lighting building regulations. A dedicated low energy light fitting will only accept low energy light bulbs. Building and structures including but not limited to overhangs and canopies. Or the lighting fittings have sockets that can only be used with lamps having an efficacy greater than 40 lumens per circuit-Watt.
Low energy light fittings must have a luminous efficacy greater than 45 lmW and a total output exceeding 400 lumens. To replace the fitting in the hall or landing when creating a new room - depending on the likely extent of use of the new room light compared to the hall or landing. Some building regulations might require that dedicated low energy lights are used.
An increase of 07 watts per square foot is allowed to highlight art or for exhibits bringing maximum allowable lighting power density for exhibit space to 14 watts per square foot. Seattle has adopted the 2018 International Building Code with amendments specific to our city. Lighting control requirements will drive building energy reduction MAGAZINE.
If a low energy lamp is fitted that is below 5 watts it is ignored from the scope and not counted. Standard bayonet or Edison screw sockets are acceptable for all low energy lamps with integral control gear like LEDs and CFLs. A low energy light is only classed as low energy if it produces over 400 lamp lumens and has an efficacy of over 45 lumens per watt.
You should check this with your local building control officer. The Seattle Building Code SBC provides minimum requirements for design and construction of new buildings. The new 2013 building regulations which came into effect in April 2014 means that at least 30 of lighting must be low energy and at least 75 of fittings must be low energy for continuously populated areas.
As with normal light. For non-dwellings the standards have been raised in three specific ways. The Building Regulations no longer require dedicated lampholderssockets for low energy lamps.