How To Ground Outdoor Light Fixture

Grounding Light Fittings A light is wired to a circuit by feeding the necessary wires through a light box.

How to ground outdoor light fixture. If your house is wired properly youll have a dedicated ground wire -- the bare one -- to connect to the fixtures ground wire which is either bare or covered with green insulation. Use chain pliers or pliers with a screwdriver to open the link on the end of the chain. If not look for a screw hole in the box.

An additional ground wire may be installed to provide a ground wire to the light fixture location. Depending on the age of the home there may be a ground wire attached to the metal box. Just make sure the neutral terminal goes to the lamp socket shell and that there is a max of about 1vac between this shell and earth ground when the lamp is on the 1v being due to other appliances drawing current on this same circuit.

This could only be verified when using a voltage tester. If the box is metal then attach the fixture ground wire to the box. This box can be made of either plastic or metal and is attached to the stud or joist and concealed from final view with a faceplate.

Attach the chain to the screw collar then hold the light fixture up against it. Lift the old light fixture off from the wall. Putting a screw in an electrical box can be a pain.

While holding the light fixture untwist the plastic wire connectors and wire ends to disconnect. You can put a short 8-32 machine screw in the hole then connect the ground wire to that screw. A grounding clip may also be.

If the box is not metal and a ground wire is not available in the fixture box then you can still install the key less light fixture. Adjust the length of the chain to the link that. Replace the Mounting Bracket.