Bathroom Lighting Zones Explained

These areas must have a particular minimum IP rating that protects against water immersion - in this.

Bathroom lighting zones explained. Bathroom lighting regulation zones are as follows. Bathroom Zones All installations must comply to the guidelines which are based on a zone area which is similar to the installation of lighting around a swimming pool area. Bathroom lighting zones are based on how close they are to water and how likely any light fixtures in the zone will get wet.

Zone 1 is the area above the bath or shower to a height of 225m from the floor. Electrical safety regulations exist to break down the bathroom space into clearly-defined zones so that you can select the appropriate light fitting to ensure everyone who uses the bathroom. For example Zone 0 covers areas inside baths or showers.

Bathroom lighting zones explained. The lower the zone number the higher the IP rating needs to be. IP rating Ingress Protection Rating.

Zone 1 requires a minimum of ipx4. Its actually generally considered safer to use an IP65 rated fitting. In this zone a minimum rating of IP45 is required but it is generally accepted that IP65 is to be used.

These are areas that will typically be subjected to multidirectional splashes and so would require a rating of at least IPX4 though if they are likely to be cleaned with. All Bathroom Zones All electrical circuits in the bathroom must be protected by a 30ma Residual Current device RCD Electrical equipment exposed to water jets eg for cleaning purposes must be at least IP65 IPX5. Bathroom Zones Explained Bathroom zones are best described with reference to illustrations but the measurements stated are quite specific and must be adhered to.

Bathroom lighting zones It is always best to check with your supplier and electrician as to what lighting products are safe to be installed in different areas of the scheme. Zone 0 is inside the bath or shower itself. Zone 1 requires a light fitting to be IP44 rated or above.